Window Replacement in Huntington Beach, Sealed at Every Seam
We replace worn aluminum and vinyl windows with new units that are shimmed square, flashed and sealed so they open easily and keep water out. We also handle window retrofitting, energy efficient windows, sliding door replacement, multi-folding doors and custom glass railings for homes here and in nearby Fountain Valley and Seal Beach.
- Bonded and insured
- $2 million insurance coverage
- Authorized Crystal Pacific Windows installer
- Free in-home estimates

Windows and Doors We Install
Most of our work is window replacement, either as window retrofitting into your existing frame or as a full window installation down to the framing. We fit energy efficient windows with low-E glass for rooms that run hot, and we handle sliding door replacement and multi-folding doors for wide openings. For balconies and decks, we build custom glass railings. Each service page explains how that job is done and what affects its cost.

Window Replacement
We remove worn windows and set new vinyl units square, shimmed and sealed against the stucco so they open easily and keep water out.

Sliding Door Replacement
We replace worn sliding glass doors with new units set level, flashed and sealed so the panel rolls easily and the sill keeps water out.
Window Installation
New windows for additions, remodels and new openings, set on a sloped sill pan, shimmed square and flashed in the right order so water stays out.
Multi-Folding Doors
Folding glass door systems installed on a level sill and a header that will not sag, so the panels glide and stack the way they were designed to.
Window Retrofitting
New vinyl windows fitted over your old aluminum frames, so the stucco and interior trim stay intact and the job is done in a day.
Energy Efficient Windows
Dual-pane Low-E windows with argon fill and warm-edge spacers, installed with a sealed opening so the rated performance holds up in your home.
Custom Glass Railings
Tempered glass railings for decks, balconies and stairs, set in sealed, corrosion-resistant hardware and fastened into solid framing.

A Window Company Focused on the Install
We are a local windows and doors company serving Huntington Beach and the surrounding Orange County area. Our work is replacing and installing windows, sliding doors, multi-folding doors and glass railings. We do not try to be a general contractor. Keeping to this trade lets us focus on how each opening is prepared, set and sealed.
Many homes near the coast still have their original single-pane aluminum sliders, with pitted tracks and worn rollers from years of salt air. Replacing them is a good chance to correct the opening too. We fix out-of-square framing, replace damaged sills, and set the new frame so it drains properly. These steps are invisible once the trim is on, and they decide how the window works in 15 years.
- Insurance
- Bonded and insured; $2 million insurance coverage
- Certifications
- Authorized Crystal Pacific Windows installer
What Shapes the Price of New Windows
Window count alone does not set the price. What matters more is how each old unit comes out, what goes in its place and what we find behind the old frame. We measure every opening and look at its condition before quoting, so the number matches your home and not a guess.
Your estimate is written out line by line for each opening, with the window, glass and installation method listed. If we find something unexpected during removal, we stop and talk with you before any added work.
- Number and Size of Openings
- Larger panes need thicker glass and heavier frames, and custom sizes cost more than common ones. Picture windows and wide sliders usually price higher than standard bedroom windows.
- Retrofit or Full-Frame
- A retrofit sets the new window into the existing frame with a flush fin over the stucco, which avoids wall work. A full-frame install removes the old frame down to the studs, which costs more because of the stucco cutting, new flashing and patching.
- Glass Package
- Dual-pane glass, low-E coatings, argon fill, tempered safety glass where code calls for it, and obscure glass for bathrooms each change the price of a unit.
- Frame Material and Style
- Vinyl, fiberglass and aluminum have different costs. Operating style also matters: casements and multi-panel units have more hardware than a single slider or fixed pane.
- Access and Condition
- Second-story windows over planters or roofs take more setup. Rotted framing or water damage found under an old sill adds work, and we show you photos before we do it.
How a Window Job Runs
Most jobs follow the same five steps, from the first phone call to final cleanup.
- 1
Phone Call
Tell us how many windows or doors you are thinking about and what is wrong with them now. We set a time for a free in-home estimate.
- 2
Measure and Inspect
We measure each opening in three places, check the existing frames for rot or movement, and explain whether retrofit or full-frame makes more sense. You get a written quote with no sales pressure or obligation.
- 3
Order and Schedule
Windows are built to the measured sizes. When they arrive, we confirm a date and let you know which rooms we will need to reach.
- 4
Installation Day
We put down drop cloths, remove the old units, then set, shim, flash and seal each new window. Most single-story homes are done in a day.
- 5
Walkthrough and Cleanup
We open and lock every sash with you, remove the old frames and glass, and vacuum the work areas before we leave.
Why Our Installations Hold Up
A good window can fail early if it goes in crooked or poorly sealed. Most leaks, sticking sashes and drafts we see trace back to how the unit was set, not to the glass itself.
Authorized Crystal Pacific Windows Installer
We are an authorized Crystal Pacific Windows installer. We set those frames following the manufacturer's installation instructions, including fastener spacing and shim locations, so the product performs the way it was designed to.
Water Management at the Sill
Water that gets past a window has to drain out, not into the wall. On full-frame installs we place a sloped sill pan with a back dam and lap the flashing tape like shingles, top over bottom, so gravity carries water out. We keep weep holes open instead of caulking over them.
Square, Plumb and Shimmed
A frame that is out of square by a small amount can make a slider drag or a lock miss its keeper. We shim at the load points, check the diagonals and test every sash and lock before we seal anything.
Sealant Joints Sized to Move
Frames expand and contract with the sun. We fill deep gaps with foam backer rod before sealing so the joint can stretch without tearing, and we tool each bead for a clean line.
Hidden Problems Shown, Not Buried
If removal uncovers soft wood or old water stains, we photograph it and walk you through it before closing the opening. Covering damage with new trim only hides a leak that will come back.
Questions About Window Replacement
Something not covered here? (714) 868-8790
Should I choose a retrofit or a full-frame replacement?
If the old frame is solid, square and dry, a retrofit is usually the practical choice. The new window sets inside the existing frame, and a flush fin covers the old edge, so the stucco stays untouched. If the frame is rotted, badly out of square or has leaked into the wall, full-frame replacement lets us rebuild the opening with new flashing and a sill pan. We tell you which one each opening needs during the estimate.
Will replacing my windows damage the stucco?
A retrofit install generally leaves the stucco alone. A full-frame install requires cutting back a strip of stucco around the opening so we can remove the old nail fin and flash the new window. We discuss any patching with you up front so you know what to expect before we start.
How long does installation take?
Each window usually takes an hour or two once we are set up, depending on size and method. A typical single-story home with eight to twelve windows is often finished in one day. Full-frame jobs and large sliding or multi-folding doors take longer, and we give you a time estimate in your quote.
How do you handle wood damage hidden behind an old frame?
Years of water slipping past a cracked sill or a dried-out caulk joint can soften the framing underneath, and you often cannot see it until the old unit is pulled. If we uncover it, work on that opening pauses. We photograph the damaged wood, show you the pictures and explain what repair the framing needs so the new window sits on a sound, dry base. Nothing is added to the job until you approve it.
Do you have any current pricing offers?
Yes. Window replacement for only $495 per window with free installation (minimum purchase of 4 windows per order; some glass size and product restrictions apply). During the estimate, we confirm which of your openings qualify and quote any that do not separately.
Is there any pressure to buy at the estimate?
No. We offer free in-home estimates with no sales pressure or obligation. We measure, check the frames, explain what each opening needs and leave you a written quote to think over on your own schedule.
Will new windows make a difference in summer heat?
Dual-pane glass with a low-E coating reflects much of the sun's heat while still letting in light. That helps west-facing rooms stay cooler in the afternoon and eases the load on your air conditioning. Our energy efficient windows page goes into glass options in more detail.
Where We Work
We install windows and doors throughout Huntington Beach and neighboring cities, including Costa Mesa, Westminster, Fountain Valley, Seal Beach and Midway City. We also cover Santa Ana, Garden Grove, Newport Beach, Cypress and Stanton.
- Huntington Beach
- Costa Mesa
- Westminster
- Fountain Valley
- Seal Beach
- Midway City
- Santa Ana
- Garden Grove
- Newport Beach
- Cypress
- Stanton
If your home is close to one of these cities but not listed, call us and we will tell you whether we can come out for a free estimate.
See What Your Windows Need
We will measure your openings, check the frames and give you a written quote you can review at your own pace. No sales pressure or obligation.