ServicesWindow Retrofitting
Window Retrofitting in Huntington Beach
We replace old aluminum and single-pane windows without cutting into your stucco. The new window is set over the existing frame, squared, shimmed and sealed, so the opening stays watertight long after we leave and your walls stay untouched.

What a retrofit is and when it fits
A retrofit, sometimes called an insert or flush-fin install, removes the old sash and glass but leaves the original frame in the wall. The new window has a flat fin, often called a Z-bar, that laps over that old frame and covers it on the outside. Nothing gets cut out of the stucco, and the interior drywall and trim stay where they are.
It is the right call when the old frame is still straight and solid and the wall around it is dry. Most stucco homes built with aluminum windows fit that description. If the frame is bent, rotted or the opening leaks into the framing, a full-frame job under window replacement is the honest answer, and we will tell you which one your home needs before you spend anything.
The fin hides the old frame, but it does not fix one. That is why the small steps before the new window goes in matter more than the window itself.
What we do on every retrofit opening
- Clean removal of sash and glass
- We pull the old vents, fixed glass and any loose glazing tape, then scrape the old sill track down to bare metal. Leftover debris in the track is what keeps a new window from sitting flat.
- Frame check before anything goes in
- We check each old frame for square and level and probe the sill for soft spots. If the frame is out of square, we shim to correct it rather than forcing the new window to follow the old error.
- Continuous sealant bed behind the fin
- The fin is set into an unbroken bead of sealant on the old frame, then fastened through the frame into solid material. A gap in that bead is the most common reason retrofit windows leak at the corners.
- Weep paths left open
- New vinyl windows drain water out through weep slots at the bottom. We keep sealant and caulk away from those slots so rain that gets into the track has somewhere to go.
- Interior finishing and cleanup
- Inside, we fill the gap between the new frame and the old one and caulk it neatly to the trim. We vacuum the sills, haul away the old glass and aluminum, and wipe down the new glass.
Signs your windows are ready for a retrofit
Sliders that drag or jump the track
Worn rollers and pitted aluminum tracks make old sliding windows hard to open and easy to knock off track. Once the track itself is corroded, new rollers rarely last.
White powder on the frames
Chalky white residue on aluminum is oxidation. Near the coast, salt air speeds it up, and it eventually pits the metal and lets seals loosen.
Fog or moisture between panes
Haze inside an older dual-pane unit tells you the spacer seal around the glass edge has broken down. Moist air has replaced the insulating gas, and no cleaning or resealing brings that gas back.
Cold glass and condensation
Single-pane aluminum conducts heat right through the frame. Water beading on the inside of the frame on cool mornings is a sign the window is doing little to hold heat in.
Street noise you can hear clearly
Thin single glass and loose sashes let sound straight in. Dual-pane glass set in a properly sealed frame cuts that noticeably.
How a retrofit job runs
- 1
Free in-home estimate
We come out, measure every opening and look at the frames and sills. You get a written, line-item quote with no sales pressure or obligation.
- 2
Exact measurements and ordering
We take width and height at three points on each opening and order to the smallest reading. A window sized to the tightest point goes in without forcing and leaves room for shims and sealant.
- 3
Install day
Drop cloths go down inside first. We remove an old window only when its replacement is ready to set, so each wall opening is exposed for a short stretch rather than all at once. Most homes are finished in a single day, depending on how many windows are on the order.
- 4
Walkthrough
We open, close and lock every new window with you, show you the weep slots and how to keep them clear, and answer questions before we pack up.

What moves the cost of a retrofit
A retrofit usually costs less than full-frame work because there is no stucco to cut and patch and no interior drywall to repair. The final number depends on the windows you choose and what we find in the old frames. We list each item on your quote so you can see where the money goes.
- Number and size of windows
- Larger openings need heavier frames and bigger glass units. Ordering several windows at once spreads the setup work across more openings.
- Glass package
- Low-E coatings, tempered glass where code requires it near doors or floors, and laminated or obscure glass for bathrooms each change the price of a unit.
- Condition of the old frames
- A bent or out-of-square frame takes extra shimming and fitting. If a frame is too far gone for a retrofit, we price that opening separately so you can decide.
- Style and operation
- Sliders, single-hungs, casements and picture windows are built differently, and operating windows cost more than fixed glass.
Window retrofitting questions
Something not covered here? (714) 868-8790
Will a retrofit window make my glass area smaller?
Slightly. Because the new frame sits inside the old one, you lose a small strip of glass around the edge, usually less than an inch per side. Slim-profile vinyl frames keep that loss small, and we can show you a sample frame during the estimate.
Do you damage the stucco or interior walls?
No. The old frame stays in the wall and the new fin covers it from outside, so there is no stucco cutting or patching. Inside, the existing trim and drywall stay in place and we finish the joint with caulk.
What windows do you install?
We are an authorized Crystal Pacific Windows installer, and we fit their vinyl windows in retrofit openings. We will walk you through the frame colors, glass options and styles that suit each room.
What happens if something gets damaged while you work?
We are bonded and insured, with $2 million insurance coverage on our work. That protection applies at your home from the moment we set up until the last piece of old aluminum is hauled away. We also lay drop cloths and protect floors and furniture so it rarely comes to that.
Is there a current offer on retrofit windows?
Yes. Window replacement for only $495 per window with free installation (minimum purchase of 4 windows per order; some glass size and product restrictions apply). Ask about it when you call for your free quote, and we will tell you which of your openings qualify.
Do I need to be home on install day?
An adult should be there when the crew arrives so we can confirm the window order room by room. We also want you back before we leave to test each window together. While the work is underway, you are free to go about your day as long as we can reach every room with a window.
Keep your stucco, replace the windows
We will measure your frames, tell you whether a retrofit fits each opening and give you a written quote. We serve Huntington Beach and nearby towns including Fountain Valley, Westminster and Costa Mesa.